Rain Water / Drain Outlet - 60mm

This Rain Water / Drain Outlet – 60mm is a flat roof synthetic rubber drain outlet for downpipes. To be used with EPDM Rubberall Roofing installations, the wide base with ribbed surface provides ample anchorage for the membrane. The flanges on the cylinder form a seal with the inner surface of the pipe.

At Rubber Flat Roof, we supply the following sizes:

• Rain Water / Drain Outlet – 60mm
  Dimensions = Base 325mm (dia) Depth 405mm Pipe Diameter 60mm
• 75mm Flexible Rain Outlet
  Dimensions = Base 325mm (dia) Depth 405mm Pipe Diameter 75mm
• 100mm Flexible Rain Outlet
  Dimensions = Base 325mm (dia) Depth 400mm Pipe Diameter 100mm

How to use:

• Once rubber has been laid, Cut hole for drain to go through.

  Apply water cut off mastic to under side of flange, Then fix down using fixing plates.

  Apply Primer to drain unit and surrounding EPDM (Min 2” / 50mm cover) using scrubpad

  Lay appropriate sized flashing tape over complete drainage unit and onto EPDM ( Recommended 0.5m of 18” flashing tape over primed area.)

  Cut hole in flashing tape to allow water to drain off roof.

If you have any queries, please get in touch with our friendly team. Call us if you are unsure about the materials you need for your roof on 01392927729 or email sales@rubberflatroof.co.uk. You can also check out our Roof Calculator that estimates all the materials you will need for your rubber roofing project.